How-to
How to mix PUSH install gel
A clean mix is the difference between a flawless install and a comeback. This is the exact 3-minute mix sequence we recommend for both window tint and PPF.
- 1.
Start with a clean 20–24 oz spray bottle
Use a fresh or thoroughly rinsed spray bottle. Any soap residue from a previous mix will contaminate your new solution.
- 2.
Fill with filtered or distilled water
Hard tap water leaves mineral spots between the film and the surface. Filtered or distilled water gives the cleanest result.
- 3.
Add one PUSH packet
Tear open one pre-measured packet and pour the full contents into the bottle.
- 4.
Shake for 2 full minutes
A proper shake fully dissolves the concentrate. Skipping this leaves uneven slip and tack across the panel.
- 5.
Adjust concentration to your install style
Lighter mix = more slip for positioning. Heavier mix = more tack on the adhesive side. Tune to your preference and the film you're installing.
- 6.
Spray, squeegee, and push contamination clear
Use as your slip and tack solution. Squeegee from the center out — PUSH releases trapped water and contamination instead of holding it under the film.